Slab Hunter with flush or deck Mount base included $150.00.
A Heavy Duty spider rigging or crappie trolling T-bar system.
(1) Three inch round 1/8" thick deck or flush mount bases with four 1/4" screw holes. Jam nut, hardware cover and base included.
(2) Black polymer coated thumb knobs and Elites Crappie V Master rod holders.
(3) Schedule 40 aluminum tubing with a 1/2" threaded stainless shaft to bolt system to base.
(4) 20 wide, 1/2" thick aluminum plate, threaded for Elites locking system with a 1/2" hole in center to bolt the system together.
Pull back on rod holder to release 5/8" locking system. Push or pull rod holder while turning thumb knob to desired degree. Push rod holder forward firmly to lock degree in place.
Loosen jam nut rotate rod holder left or right. Tighten Jam nut to secure.
T-bar Horizontal adjustments: No left hand threats needed! Simply reverse rod holder stem jam nut to the bottom for left side of boat.
Loosen the akorn nut at top of T-bar plate. Rotate to desired position. Firmly tighten nut to secure.
Remove T-bar system:
Remove akron nut and disassemble unit from tubing and tubing from base. Leaving base only.
At Top! Choose T-bar height and base design.
Our heights measure from the deck to the rod in the rod holder.
Ordering more than one add Qty. and place order.
May your drags scream!
Looking for that edge? Look no further! Elite